No. P100165

1. Unique identification code of the product type:

Prestressed Concrete Lintel - Textured Finish
P100165

2. Type, batch or serial number or any other element allowing identification of the construction product as required under Article 11(4) of the CPR:

Prestressed Concrete Lintel - Textured Finish Length, L (mm): 1650
P100: Profile, h x w (mm): 65 x 100 (h = lintel height)

3. Intended use or uses of the construction product, in accordance with the applicable harmonized technical specification, as foreseen by the manufacturer:

Intended use in masonry walls and partitions - to support loads over openings with a semi-structural role in the works (up to a maximum clear span of 3.3 m)

4. Name, registered trade name or registered trade mark and contact address of the manufacturer as required under Article 11(5):

Supreme Concrete Limited
Coppingford Hall, Coppingford Road, Sawtry, Cambridgeshire, PE28 5GP, UK

5. System of assessment and verification of constancy of performance of the construction product as set out in Annex V:

System 3

6. In case of the declaration of performance concerning a construction product covered by a harmonized standard:

EN 845-2:2013
Notified Body: BRE (Notified Body ID No. 0832) performed initial type testing under AVCP System 3 and issued test/ calculation reports: No. 258-597

7. Declared performance:

Essential CharacteristicsPerformanceHarmonised
Technical
Specification
 P100EN 845-2:2013
Load bearing capacity:
(based on 150mm built-in length at each end)
7.68kN/m
Profile (height, h x width, w):65 x 100mm
Length:1650 mm
Minimum built in length:150 mm
Failure Mode(s):Flexure & Shear
Deflection at ⅓ load capacity:2.24 mm
Water absorption:1.6g/m2.s
Water vapour permeability:5/15μ
Mass per unit area:228.5kg/m²
Thermal resistance (thermal conductivity):1.00W/(m.K)
Resistance to fire:R30 
Durability (against corrosion):C2 
Durability (against freeze/thaw):Resistant 
Dangerous substances:None 
For geometrical data and load/span tables, see the Technical Documentation.

Technical Documentation:
Product Catalogue
Website: www.supremeconcrete.co.uk

8. The performance of the product identified in points 1 and 2 is in conformity with the declared performance in point 7. This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 4.

Signed for and on behalf of the manufacturer by:

Signature:
Name: Mark Yates
Position: Manufacturing Director
Place: Coppingford Hall, PE28 5GP, UK
Date: 1st February 2019